THREAD REPAIR KIT M12 x 1.75 POWERCOIL
3520-12.00K
Thread Repair
Description
Product Code: 3520-12.00
Description: 12mm x 1.75mm Powercoil Repair Kit
Number Pieces: 14
Brand: Powercoil
Tapping Drill Bit Included
Specs:
Internal Thread Diamerter: 12mm
Thread Pitch: 1.75mm
Inserts Per Kit: 10
Installed Length: 18mm
Tapping Drill Length; 12.50mm
Kit contains the wire thread inserts, tap, installation tool, the tapping drill and break off tool needed for particular sizes of PowerCoil insert.
12.4mm Bright Finish HSS Jobber Drill
12 x 1.75mm STI MC Intermediate HSS Tap
12 x 1.75mm x 1.5D MC Wire Thread Inserts
HIT15 PowerCoil Hand Installation Tool
TB15 PowerCoil Tang Break Tool
Installation Instructions
Instructions:
1. DRILL - Drill to clear out the damaged thread with drill size as specified on kit (if necessary)
2. CHECK - Ensure the tap thread matches the bolt thread.
3. TAP - Tap thread carefully using correct procedures.
4. SET TOOL - Place insert on installation tool, positioning the adjustable stop so that the inset tang is centered in the tang slot.
5. INSTALL - Wind insert in with light downward pressure until 1/4 - 1/2 turn below the surface.
6. TANG REMOVAL - Do not attempt to twist tang off with tool. Lift tool from tang, turn tool 90 degrees and tap down sharply. Use tang break off tool where supplied. For sparkplug and large fine threads, use long nosed pliers to pull tang out
Questions?
You may also like
THREAD REPAIR KIT UNF 1/2-20
