THREAD REPAIR KIT M4 x 0.7 POWERCOIL
3520-4.00K
Thread Repair
Description
Product Code: RE35048
Description: 4mm x 0.7mm Powercoil Repair Kit
Number Pieces: 24
Brand: Powercoil
Tapping Drill Included
Specs:
Size: 4mm
Thread Pitch: 0.7mm
Inserts Per Kit: 20
Installed Length: 6.00mm
Tapping Drill 4.20mm
Contains:
4 x 0.7mm STI MC Intermediate HSS Tap
20 4 x 0.7mm x 1.5D MC Wire Thread Inserts
HIT6 PowerCoil Hand Installation Tool
TB6 PowerCoil Tang Break Tool
4.2mm Bright Finish HSS Jobber Drill
Installation Instructions
Notes:
Everything you need for complete thread repair in one handy case.
Includes only the best quality HSS Taps which make them suitable for aluminium, magnesium, cast iron and most machinable steels.
Provides a strong female thread.
Available in most thread forms.
Available in varying lengths.
Manufactured in 304 stainless steel.
Powercoil manufacture a comprehensive range of inserts, tooling and complimentary products for repair and maintenance of stripped or damaged threads. Recoil inserts are made from high strength stainless steel wire, wound to the shape of a spring. The insert is compressed during installation, and springs back permanently anchoring the insert into place. The Recoil insert is bigger than the tapped hole and is normally stronger than the original thread. Powercoil inserts can be installed with manual or power tooling.
Also known as RECOIL and HELICOIL
Kit includes Installation Tools, Tap and Inserts
Instructions:
1. DRILL - Drill to clear out the damaged thread with drill size as specified on kit (if necessary)
2. CHECK - Ensure the tap thread matches the bolt thread.
3. TAP - Tap thread carefully using correct procedures.
4. SET TOOL - Place insert on installation tool, positioning the adjustable stop so that the inset tang is centered in the tang slot.
5. INSTALL - Wind insert in with light downward pressure until 1/4 - 1/2 turn below the surface.
6. TANG REMOVAL - Do not attempt to twist tang off with tool. Lift tool from tang, turn tool 90 degrees and tap down sharply. Use tang break off tool where supplied. For sparkplug and large fine threads, use long nosed pliers to pull tang out
Questions?
You may also like
THREAD REPAIR KIT UNF 1/2-20
